Altronix EFLOW6NA8 Access Power Controller w/ Power Supply/Charger, 8 Fused Relay Outputs, 12/24VDC, 6A, Aux Output, FAI, 115VAC, BC400 Enclosure

$399.99
        • Input
          • Input 120VAC 60Hz, 3.5A.
            • Power supply input options:
              • a) One (1) common power input for ACM8 and lock power (factory installed).
              • b) Two (2) isolated power inputs - One (1) to power the ACM8 and one (1) for lock accessory power, (external power supply is required). Current is determined by the power supply connected, not to exceed a maximum of 10A total.
          • Eight (8) Access Control System trigger inputs.
            • Input options:
              • a) Eight (8) normally open (NO) inputs.
              • b) Eight (8) open collector inputs.
              • c) Any combination of the above.
          • ACM8 board main fuse is rated at 10A.
        • Output
          • 12VDC or 24VDC outputs @ 6A supply current.
          • Eight (8) independently trigger controlled outputs.
            • Output options:
              • a) Eight (8) Fail-Safe filtered power outputs.
              • b) Eight (8) Fail-Secure filtered power outputs.
              • c) Eight (8) form "C" relay outputs (rated @ 5A/24VDC or VAC).
              • d) Any combination of the above.
          • Eight (8) unswitched filtered aux. power outputs (outputs are rated @ 2.5A).
          • Over Voltage protection.
          • Short circuit and thermal overload protection.
        • Fire Alarm Disconnect
          • Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
            • Fire Alarm disconnect input options:
              • a) Normally open (NO) or normally closed (NC) dry contact input.
              • b) Polarity reversal input from FACP signaling circuit.
          • Alarm output relay indicates that FACP input is triggered (form "C" contact rated @ 1A 28VDC not evaluated by UL).
        • Supervision
          • AC fail supervision (form "C" contacts).
          • Battery fail & presence supervision (form "C" contacts).
          • Low power shutdown. Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
        • Visual Indicators
            • ACM8 Access Power Controller:
              • Red LEDs indicate outputs are triggered (relays energized).
              • Green LED indicates FACP disconnect is triggered.
            • eFlow Power Supply Board:
              • AC input and DC output LED indicators.
        • Battery Backup
          • Built-in charger for sealed lead acid or gel type batteries.
          • Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption.
          • Zero voltage drop when unit switches over to battery backup (AC failure condition).
        • Electrical
            • Temperature:
              • Operating: 0° C to 49° C (32° F to 120° F).
              • Storage: - 20° C to 70° C ( - 4° F to 158° F).
          • Relative Humidity: 85% +/- 5%.
            • BTU/Hr.:
              • 12VDC: 37 BTU/Hr.
              • 24VDC: 74 BTU/Hr.

You may also like

Recently viewed